3 Pin CDI Set, 1975-77, for 123 Distributors

Product Description:

Partsklassik CDI Set, 3 Pin
For Porsche 911 models 1975-77.
Direct replacement for the factory parts, with improved performance.
Extra power feed for use with a 123 electronic distributor.
We no longer recommend using Pertronix ignitors with CDI.
Use with factory spec solid core ignition wires and plugs.

This set includes:

Partsklassik CDI Box 3 pin, New
   - Our true 450 Volt digital CDI in a new, US-made aluminum case
   - Won’t lose power as RPMs increase
   - Rev limit switch with multiple settings (default setting is no limit)
   - Built-in protections from bad trigger signals & other external threats.

CDI Ignition Coil by Partsklassik 
   - Factory-correct transformer coil for all Porsche CDI systems

3 Pin CDI Harness for 123 distributors or original Pertronix Ignitor
   - Hand made in the USA by skilled workers

5K Ohm resistor*

Bracket and high quality decals are included.


*Today's replacement rotors (yes, including OEM) often have insufficient resistance for Porsche CDI systems. Check your rotor’s resistance, and if it’s only 0-1.5K ohms instead of the factory 5K ohms, then install the 5K resistor on your cap to coil wire. 3-Pin CDI systems also require solid core wires with 1k ohms resistance on each plug connector. Failure to maintain these values will void this set’s warranty. See our Technical Service Bulletin for additional information.

Manufacturer Information:

Partsklassik
Partsklassik was founded by a Porsche®-trained mechanic with decades of repair and restoration experience. We are a parts and components restorer, as well as a manufacturer of previously unavailable parts for vintage and classic Porsche® vehicles. 

We also carry thousands of OEM and aftermarket parts spanning all systems of the air cooled Porsche® models, including the 356, 911, 912, 914, and 930. We continuously add new products and services to meet the needs of the vintage Porsche® enthusiast. 

Reviews and Ratings:

• 1975 Porsche 911
• 1976 Porsche 911
• 1977 Porsche 911

All returns require pre-approval. All returns are subject to a 25% restocking fee, with the exception of approved warranty returns, or if we ship a different part number than ordered. We do not accept returns after 30 days.

Inspect your order immediately when it arrives. We must be notified within 5 days if there are any missing, damaged, or incorrect parts.

Returns (except warranty) won't be accepted if the part:
 - Has been installed, used, damaged, is dirty or incomplete
 - Is not sellable as new
 - Arrived in sealed packaging that has been opened
 - Is an electrical part, a distributor spring, a custom or cut-to-length item, or a Special Order
 - Was purchased more than 30 days earlier

Parts must be returned properly padded in a sturdy cardboard box. Returns sent in envelopes will be refused. Items damaged in transit to us cannot be refunded. All returns must be shipped prepaid.