1980 Porsche 911SC Chain Tensioner Holding Tool

Product Description:

Chain Tensioner Holding tool
This small but essential tool holds the compressed chain tensioner while it is being installed.

Before an overhauled chain adjuster is installed, the adjuster piston must be moved to bottom dead center. Clamp the chain adjuster into a vice so that as the jaws are slowly closed the piston is pressed down to the lower limit of its travel. If the piston is moved too fast, the rubber seal rings will be damaged and the oil in the chamber will escape. In this position, pre-load the piston with P214 tool and install the chain adjuster. After installing, check valve timing as usual and adjust if needed.

Manufacturer Information:

Sir Tools has been making specialty tools since 1970.

Reviews and Ratings:

• 1965 Porsche 911
• 1967 Porsche 911
• 1968 Porsche 911
• 1969 Porsche 911
• 1970 Porsche 911
• 1972 Porsche 911
• 1973 Porsche 911
• 1974 Porsche 911
• 1975 Porsche 911
• 1976 Porsche 911
• 1977 Porsche 911
• 1978 Porsche 911SC
• 1979 Porsche 911SC
• 1980 Porsche 911SC
• 1981 Porsche 911SC
• 1982 Porsche 911SC
• 1983 Porsche 911SC
• 1970 Porsche 914/6
• 1971 Porsche 914/6
• 1972 Porsche 914/6
• 1973 Porsche 914/6
• 1974 Porsche 914/6
• 1975 Porsche 914/6
• 1976 Porsche 914/6
• 1975 Porsche 930
• 1976 Porsche 930
• 1977 Porsche 930
• 1978 Porsche 930
• 1979 Porsche 930
• 1980 Porsche 930
• 1981 Porsche 930
• 1982 Porsche 930
• 1983 Porsche 930

All returns require pre-approval. All returns are subject to a 25% restocking fee, with the exception of approved warranty returns, or if we ship a different part number than ordered. We do not accept returns after 30 days.

Inspect your order immediately when it arrives. We must be notified within 5 days if there are any missing, damaged, or incorrect parts.

Returns (except warranty) won't be accepted if the part:
 - Has been installed, used, damaged, is dirty or incomplete
 - Is not sellable as new
 - Arrived in sealed packaging that has been opened
 - Is an electrical part, a distributor spring, a custom or cut-to-length item, or a Special Order
 - Was purchased more than 30 days earlier

Parts must be returned properly padded in a sturdy cardboard box. Returns sent in envelopes will be refused. Items damaged in transit to us cannot be refunded. All returns must be shipped prepaid.