1979 Porsche 911SC 6 Pin CDI Wiring Harness, for 123

Product Description:

6 Pin CDI Harness for 123
Order this version if using a 123 distributor sold by Partsklassik.
Requires the male plug kit that we include with the 123.

This harness is designed for the 911SC models using the 6 pin CDI system and a 123 distributor. Until now the only way to replace a damaged ignition harness on the SC models was to replace the entire engine harness. This is very expensive and time consuming to do.

We have designed this harness to allow the mechanic to just replace the wiring harness that controls the ignition function of the vehicle. The harness will directly connect to the CDI Box, the coil, and the male connector that we supply with the 123 distributor.  Two connections that will require some plug disassembly are the 12V ignition connection at the rear fuse panel and the tachometer signal wire at the 14 pin plug connector.

Includes free download of CDI System TSB.

Excludes the Bosch “green wire” which isn’t a direct fit for 123 wiring. 

Please note:
Our harnesses are intended for installation by experienced professional mechanics who are familiar with Porsche CDI systems and safe shop practices, and who have access to Porsche factory manuals and/or applicable ignition wiring diagrams. Installation instructions are not included.  

Manufacturer Information:

Partsklassik
Partsklassik was founded by a Porsche®-trained mechanic with decades of repair and restoration experience. We are a parts and components restorer, as well as a manufacturer of previously unavailable parts for vintage and classic Porsche® vehicles. 

We also carry thousands of OEM and aftermarket parts spanning all systems of the air cooled Porsche® models, including the 356, 911, 912, 914, and 930. We continuously add new products and services to meet the needs of the vintage Porsche® enthusiast. 

Reviews and Ratings:

• 1978 Porsche 911SC
• 1979 Porsche 911SC
• 1980 Porsche 911SC
• 1981 Porsche 911SC
• 1982 Porsche 911SC
• 1983 Porsche 911SC

All returns require pre-approval. All returns are subject to a 25% restocking fee, with the exception of approved warranty returns, or if we ship a different part number than ordered. We do not accept returns after 30 days.

Inspect your order immediately when it arrives. We must be notified within 5 days if there are any missing, damaged, or incorrect parts.

Returns (except warranty) won't be accepted if the part:
 - Has been installed, used, damaged, is dirty or incomplete
 - Is not sellable as new
 - Arrived in sealed packaging that has been opened
 - Is an electrical part, a distributor spring, a custom or cut-to-length item, or a Special Order
 - Was purchased more than 30 days earlier

Parts must be returned properly padded in a sturdy cardboard box. Returns sent in envelopes will be refused. Items damaged in transit to us cannot be refunded. All returns must be shipped prepaid.