Part#: 901.108.948.00
Availability: In Stock
Weber IDA IDS Gasket Kit Contains the gaskets for one Weber 3-series carburetor. Suitable for a quick carb clean out, not a major overhaul. Sold per each, one kit per carburetor. If doing a full overhaul, see our Master Gasket Kit for Webers. The Master Kit includes 40-50 more parts including additional seals, hardware, teflon bushings, and needles & seats. We also recommend replacing the following during a full overhaul: Throttle Plates (edge wear of plates is common) sku# 901.100.965.00 for 40mm Check that you don't need larger plates due to wear of bore. Plugs for Needle & Seats (common source of leaks) sku# 901.100.801.00 Fuel Inlet Strainers sku# 901.100.808.00 Float Bowl Plugs (they easily snap when old, over-tightened) sku# 901.100.806.00 Accelerator pump lever (“ear” attached to throttle rod) sku# 45027.007 Accelerator pump rod assembly (left and right) sku# 61287.003, and 61287.002 Accelerator pump pivot pin sku# 32486.000 Mixture Screws and Screw Springs sku# 64750.003 and 47600.007 Finally, be sure to check for the following and replace if needed: Brass floats that are collapsed in, corroded, leaky Throttle shafts that are worn to 7.95mm or less, or heavily scored Auxiliary boosters and chokes with damaged or modified surfaces Jets that are deformed or twisted from over-tightening and age Corroded or twisted main jet holders
Partsklassik Partsklassik was founded by a Porsche®-trained mechanic with decades of repair and restoration experience. We are a parts and components restorer, as well as a manufacturer of previously unavailable parts for vintage and classic Porsche® vehicles. We also carry thousands of OEM and aftermarket parts spanning all systems of the air cooled Porsche® models, including the 356, 911, 912, 914, and 930. We continuously add new products and services to meet the needs of the vintage Porsche® enthusiast.
All returns require pre-approval. All returns are subject to a 25% restocking fee, with the exception of approved warranty returns, or if we ship a different part number than ordered. We do not accept returns after 30 days. Inspect your order immediately when it arrives. We must be notified within 5 days if there are any missing, damaged, or incorrect parts. Returns (except warranty) won't be accepted if the part: - Has been installed, used, damaged, is dirty or incomplete - Is not sellable as new - Arrived in sealed packaging that has been opened - Is an electrical part, a distributor spring, a custom or cut-to-length item, or a Special Order - Was purchased more than 30 days earlier Parts must be returned properly padded in a sturdy cardboard box. Returns sent in envelopes will be refused. Items damaged in transit to us cannot be refunded. All returns must be shipped prepaid.